Lexus ES: Installation
INSTALLATION
PROCEDURE
1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
(a) Pass the hood lock control cable assembly into the engine compartment.
(b) Engage the grommet.
(c) Engage each clamp.
(d) Engage the clamp to install the hood lock control cable assembly.
2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
(a) Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.
3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Click here .gif)
4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
5. INSTALL INSTRUMENT SIDE PANEL LH
Click here
6. INSTALL FRONT DOOR OPENING TRIM COVER LH
Click here
7. INSTALL COWL SIDE TRIM BOARD LH
Click here
8. INSTALL FRONT DOOR SCUFF PLATE LH
Click here
9. INSTALL HOOD LOCK ASSEMBLY
(a) Apply MP grease to the sliding areas of the hood lock assembly.
(b) Connect the hood lock control cable assembly to the hood lock assembly.
(c) Install the hood lock assembly with the 2 bolts and hood lock bolt.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
HINT:
The hood lock nut cap is a non-reusable part. Be sure to install it after inspecting and adjusting the hood sub-assembly.
(d) except TMMK Made Gasoline Model:
(1) Connect the connector.
(e) for TMMK Made Gasoline Model:
(1) Connect the connector.
(2) Engage the clamp.
10. ADJUST HOOD SUB-ASSEMBLY
Click here
11. INSTALL COOL AIR INTAKE DUCT SEAL
Click here
12. INSTALL FRONT FENDER LINER RETAINER
Click here
13. INSTALL REAR FENDER SPLASH SHIELD SUB-ASSEMBLY LH
HINT:
Use the same procedure as for the RH side.
Click here
14. INSTALL PIN HOLD CLIP
HINT:
Use the same procedure as for the RH side.
Click here
15. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
HINT:
Use the same procedure as for the RH side.
Click here
16. INSTALL FRONT WHEEL LH
Click here
