Lexus ES: Door / Hatch
Lexus ES (XZ10) Service Manual / Vehicle Interior / Door / Hatch
- Front Door
- Front Door Opening Trim Weatherstrip
- Fuel Lid Opener Motor Assembly
- Fuel Lid Opener Switch
- Fuel Lid Opener System (for Gasoline Model)
- Fuel Lid Opener System (for Hv Model)
- Hood
- Hood Lock Control Cable Assembly
- Hood Support
- Kick Sensor
- Luggage Compartment Door
- Luggage Compartment Door Closer Switch
- Luggage Compartment Door Opener Inner Switch
- Luggage Compartment Door Opener Main Switch
- Luggage Compartment Door Opener Outer Switch
- Luggage Compartment Door Opener System (for Gasoline Model)
- Luggage Compartment Door Opener System (for Hv Model)
- Luggage Compartment Door Support
- Luggage Compartment Door Weatherstrip
- Luggage Door Hinge Torsion Bar
- Power Trunk Lid System (for Gasoline Model)
- Power Trunk Lid System (for Hv Model)
- Rear Door
- Rear Door Opening Trim Weatherstrip
- Trunk Lid Actuator
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for Driver Side *B for Front Passenger Side *C w/ Illumination - - *1 BOX BOTTOM MAT *2 COURTESY LIGHT ASSEMBLY *3 DOOR ARMREST COVER *
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during
SEE MORE:
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE CLUTCH DRUM OIL SEAL RING (a) Remove the 4 clutch drum oil seal rings from the stator shaft assembly. NOTICE: Do not expand the gap of the clutch drum oil seal rings excessively. 2. REMOVE OIL STRAINER ASSEMBLY (a) Using a T30 "TORX" socket wrench, r
Inspection
INSPECTION PROCEDURE 1. INSPECT TURN SIGNAL SWITCH (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Light Control Switch Tester Connection Condition Specified Condition
*1: w/ Light Control Switch DRL OFF Position
2 (L_OFF) - 12 (EL)
© 2016-2025 Copyright www.lexguide.net
