Lexus ES manuals

Lexus ES: Freeze Frame Data

FREEZE FRAME DATA

DESCRIPTION

(a) Whenever a lane control system DTC is stored, the forward recognition camera stores the current vehicle state as Freeze Frame Data.

CHECK FREEZE FRAME DATA

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Chassis / Lane Control / Trouble Codes.

Chassis > Lane Control > Trouble Codes

(e) According to the display on the Techstream, select a DTC to display its freeze frame data.

Chassis > Lane Control

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Total Distance Traveled

-

-

-

Cannot be used

Total Distance Traveled - Unit

-

-

-

Cannot be used

LDA Control

Lane control system control status

Prohibit or Permit

Prohibit: Control prohibited

Permit: Control permitted

-

Turn Switch (Right)

Right turn signal switch status

OFF or ON

ON: Right turn signal switch on

OFF: Right turn signal switch off

-

Turn Switch (Left)

Left turn signal switch status

OFF or ON

ON: Left turn signal switch on

OFF: Left turn signal switch off

-

Vehicle Information (2WD/4WD)

-

-

-

Cannot be used

Vehicle Information (Conv/HV)

-

-

-

Cannot be used

READ NEXT:

 Fail-safe Chart

FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) When a malfunction occurs in the lane control system, a message will be displayed on the multi-information display and, depending on the malfunction, functions o

 Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa

 Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Lane Control System DTC No. Detection Item Link C1A7496 Steering Vibrator Component Internal Failure U010087 Lost Communication with ECM/PCM "A" M

SEE MORE:

 Drive Motor "A" Performance (P0A9000)

DTC SUMMARY MALFUNCTION DESCRIPTION This DTC indicates that magnetic force deterioration of the permanent magnet located in the rotor inside the motor (MG2) has been detected. The cause of this malfunction may be one of the following: Area Main Malfunction Description Inverter Inverter wi

 Components

COMPONENTS ILLUSTRATION *A Type A *B Type B *1 FRONT FENDER APRON SEAL LH *2 FRONT FENDER APRON SEAL RH *3 FRONT LOWER BUMPER ABSORBER *4 FRONT WHEEL OPENING EXTENSION PAD LH *5 FRONT WHEEL OPENING EXTENSION PAD RH *6 NO. 1 ENGINE UNDER COVER *7 NO. 3 EN

© 2016-2024 Copyright www.lexguide.net