Lexus ES: Software Incompatibility with Cruise Control Module Invalid/Incompatible Software Component (U030557)
DESCRIPTION
The millimeter wave radar sensor assembly receives vehicle information from the forward recognition camera via CAN communication.
If the vehicle information stored in the forward recognition camera differs from that stored in the millimeter wave radar sensor assembly, the millimeter wave radar sensor assembly stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U030557 | Software Incompatibility with Cruise Control Module Invalid/Incompatible Software Component | When the power switch is on (IG), the vehicle information stored in the millimeter wave radar sensor assembly differs from that received from the forward recognition camera |
|
CAUTION / NOTICE / HINT
NOTICE:
- When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle and a DTC may be stored.
-
When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the millimeter wave radar sensor beam axis must be performed.
Click here
.gif)
- When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.
-
If the forward recognition camera has been replaced with a new one, forward recognition camera adjustment must be performed.
HINT:
Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.
One Time Recognition: Click here
Sequential Recognition: Click here
PROCEDURE
| 1. | CHECK FOR DTCs |
(a) Check for DTCs.
Body Electrical > Front Radar Sensor > Trouble Codes Chassis > Front Recognition Camera > Trouble Codes| Result | Proceed to |
|---|---|
| DTC U030557 (Front Radar Sensor) and U032257 (Front Recognition Camera) are output | A |
| Only DTC U030557 (Front Rader Sensor) is output | B |
| A | .gif) | REPLACE FORWARD RECOGNITION CAMERA |
| B | | REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY |
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the
Parts Location
PARTS LOCATION ILLUSTRATION *1 FORWARD RECOGNITION CAMERA *2 MILLIMETER WAVE RADAR SENSOR ASSEMBLY *3 BRAKE ACTUATOR ASSEMBLY - SKID CONTROL ECU *4 RACK AND PINION POWER STEERING G
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL REAR COMBINATION LIGHT ASSEMBLY (for TMMK Made) 2. INSTALL REAR BUMPER UPPER RETAINER (for TMMK Made) Click here 3. INSTALL REAR B
Front Passenger Side Power Mirror cannot be Adjusted with Power Mirror Switch
DESCRIPTION The outer mirror switch assembly sends the mirror adjust switch signals to the main body ECU (multiplex network body ECU). The main body ECU (multiplex network body ECU) then sends the received mirror adjust switch signals to the outer mirror control ECU assembly (front passenger door) v
