Lexus ES: Rear Door Window Frame Moulding
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Exterior Panels / Trim / Rear Door Window Frame Moulding
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 REAR DOOR FRONT WINDOW FRAME MOULDING *2 REAR DOOR WEATHERSTRIP *3 REAR DOOR WINDOW FRAME MOULDING SUB-ASSEMBLY *4 RIVET ● Non-reusable part -
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rea
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL REAR DOOR WINDOW FRAME MOULDING
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 COWL TOP PANEL INSULATOR *2 FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY *3 HEADLIGHT ASSEMBLY - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *A for TMC Made - - *1 HEADLIGHT ECU SUB-ASSEMBLY *2 HEADLIGHT GASKE
Installation
INSTALLATION PROCEDURE 1. INSTALL SLIDING ROOF OR REMOVABLE ROOF HOUSING SUB-ASSEMBLY (a) Loosen the 4 bolts of the brackets of the sliding roof or removable roof housing sub-assembly. (b) Temporarily install the sliding roof or removable roof housing sub-assembly with the 6 nuts and 8 bolts. (c)
© 2016-2024 Copyright www.lexguide.net
