Lexus ES: Fuel Lid Opener System (for Hv Model)
Lexus ES (XZ10) Service Manual / Vehicle Exterior / Door / Hatch / Fuel Lid Opener System (for Hv Model)
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Problem Symptoms Table
- Data List / Active Test
- Fuel Lid Opener does not Operate
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following s
Parts Location
PARTS LOCATION ILLUSTRATION *1 FUEL LID OPENER SWITCH *2 DLC3 *3 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - FUEL OPN RELAY *4 COMBINATION METER ASSEMBLY *5 ECM *6 NO. 1 E
System Diagram
SYSTEM DIAGRAM
SEE MORE:
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL FRONT DRIVE SHAFT BEARING (for RH Side) (a) Using SST, a steel plate and a press, install a new front drive shaft bearing. SST: 09527-10011 NOTICE: The bearing should be completely installed. *a Steel Plate (b) Using a snap ring expander,
Removal
REMOVAL PROCEDURE 1. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY Click here 2. REMOVE DRIVE MODE SELECT SWITCH (COMBINATION SWITCH ASSEMBLY) (a) Disconnect the drive mode select switch (combination switch assembly) connector. (b) Disengage the clamp to disconnect the wire harne
© 2016-2025 Copyright www.lexguide.net
