Lexus ES manuals

Lexus ES: Data List / Active Test

DATA LIST / ACTIVE TEST

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

DATA LIST

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Central Gateway / Data List.

Body Electrical > Central Gateway > Data List

Tester Display

IG2 SW

IG1 SW

ACC SW

+B Voltage

Number of DTC

(e) Read the Data List.

Body Electrical > Central Gateway > Data List

Tester Display

Measurement Item

Range

Normal Condition

IG2 SW

Power switch on (IG) signal (IG2 terminal)

OFF or ON

OFF: Power switch on (ACC) or off

ON: Power switch on (IG)

IG1 SW

Power switch on (IG) signal (IG1 terminal)

OFF or ON

OFF: Power switch on (ACC) or off

ON: Power switch on (IG)

ACC SW

Power switch on (ACC) signal (ACC terminal)

OFF or ON

OFF: Power switch off

ON: Power switch on (ACC) or ON

+B Voltage

Auxiliary battery voltage (BATT terminal)

Over 8 V or Under 8 V

Over 8 V: Auxiliary battery voltage 8 V or higher

Under 8 V: Auxiliary battery voltage below 8 V

Number of DTC

Number of DTCs

0 to 255

0: Normal

READ NEXT:

 Fail-safe Chart

FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) When communication fails in any of the CAN bus lines (communication lines), a fail-safe function(s) will operate. The fail-safe function that is specified for ea

 Dtc Check / Clear

DTC CHECK / CLEAR CHECK FOR DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Central Gateway

 Diagnosis System

DIAGNOSIS SYSTEM CHECK FOR INSTALLED SYSTEMS (ECUS AND SENSORS) THAT USE CAN COMMUNICATION (a) The systems (ECUs and sensors) that use CAN communication vary depending on the vehicle and optional equi

SEE MORE:

 DC/DC Converter Voltage Sensor "A"(VL) Circuit Voltage Above Threshold (P0E5717)

DTC SUMMARY MALFUNCTION DESCRIPTION If an overvoltage malfunction occurs in the motor inverter or generator inverter, the motor generator control ECU (MG ECU) detects the malfunction and stores this DTC. The cause of this malfunction may be one of the following: Area Main Malfunction Descriptio

 Dtc Check / Clear

DTC CHECK / CLEAR CHECK FOR DTC (MAIN BODY) (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Main Body / Trouble Codes. Body Electrical > Main Body > Trouble Codes (e) Check for DTCs. CHECK

© 2016-2025 Copyright www.lexguide.net