Lexus ES: Front Right Sensor Malfunction (C1AE4)
DESCRIPTION
The front corner ultrasonic sensor RH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front corner ultrasonic sensor RH. If the front corner ultrasonic sensor RH has an open circuit or other malfunction, it will not function normally.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE4 | Front Right Sensor Malfunction | A malfunction of the front corner ultrasonic sensor RH. |
|
CAUTION / NOTICE / HINT
NOTICE:
If DTCs are output after repairs, turn the power switch on (IG) and the parking support alert system on. Then clear the DTCs.
Click here .gif)
PROCEDURE
| 1. | CHECK DTC OUTPUT |
(a) Check for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes| Result | Proceed to |
|---|---|
| Only DTC C1AE4 is output | A |
| DTC C1AE4 and C1AEC are output | B |
| No DTCs are output | C |
| B | .gif) | GO TO DTC (C1AEC) |
| C | | USE SIMULATION METHOD TO CHECK |
|
.gif)
| 2. | REPLACE FRONT CORNER ULTRASONIC SENSOR RH |
(a) Replace the front corner ultrasonic sensor RH with new or a known good one.
Click here
HINT:
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
|
| 3. | CHECK DTC OUTPUT |
(a) Clear the DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs(b) Check for DTCs.
Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes| Result | Proceed to |
|---|---|
| DTC C1AE4 is output | A |
| No DTCs are output | B |
| A | | REPLACE CLEARANCE WARNING ECU ASSEMBLY |
| B | | END (FRONT RIGHT CORNER SENSOR WAS DEFECTIVE) |
READ NEXT:
Rear Left Sensor Malfunction (C1AE6)
DESCRIPTION The rear corner ultrasonic sensor LH is installed to the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear corner ultrasonic sensor
Rear Left Center Sensor Malfunction (C1AE7)
DESCRIPTION The rear center ultrasonic sensor LH is installed to the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear center ultrasonic sensor
Rear Right Center Sensor Malfunction (C1AE8)
DESCRIPTION The rear center ultrasonic sensor RH is installed to the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear center ultrasonic sensor
SEE MORE:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Chassis / Rear Camera / Trouble Codes. Chassis > Rear Camera > Trouble Codes (e) Enter the following menus: Body Electrical / Navig
Installation
INSTALLATION PROCEDURE 1. INSTALL REMOTE OPERATION CONTROLLER ASSEMBLY (a) Install the remote operation controller assembly with the 4 screws as shown in the illustration. Install in this Direction 2. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY Click here 3. INSTALL SHIFT LEVER KNOB SU
