Lexus ES: Cruise Control System Internal Failure (P057504,P057549)
DESCRIPTION
When the hybrid vehicle control ECU detects an internal malfunction, DTC P057504 or P057549 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | DTC Output from |
|---|---|---|---|---|---|
| P057504 | Cruise Control System Internal Failure | When the dynamic radar cruise control system is operating, the hybrid vehicle control ECU detects a malfunction in the internal cancel circuit for 0.4 seconds or more. | Hybrid vehicle control ECU | Does not come on | Hybrid Control |
| P057549 | Cruise Control Internal Electronic Failure | When the dynamic radar cruise control system is operating, the hybrid vehicle control ECU detects a malfunction in the internal STP signal circuit for 0.2 seconds or more. | Hybrid vehicle control ECU | Does not come on | Hybrid Control |
CAUTION / NOTICE / HINT
NOTICE:
Before replacing the hybrid vehicle control ECU, refer to Registration.
Click here .gif)
PROCEDURE
| 1. | CHECK FOR DTCs |
(a) Clear the DTCs.
Powertrain > Radar Cruise1 > Clear DTCs(b) Make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.
(c) Check for DTCs.
Powertrain > Radar Cruise1 > Trouble Codes| Result | Proceed to |
|---|---|
| DTC P057504 and P057549 are not output. | A |
| DTC P057504 or P057549 is output. | B |
| A | .gif) | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE HYBRID VEHICLE CONTROL ECU |
READ NEXT:
Brake System (P157800)
DESCRIPTION When a malfunction in the electronically controlled brake system is detected, DTC P157800 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area MIL DTC Output
Cruise Control Input Processor (P160700)
DESCRIPTION When the hybrid vehicle control ECU detects that it is not functioning normally, DTC P160700 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area MIL DTC Out
Communication Error from VSC to ECM Invalid Serial Data Received (P163081)
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) sends signals such as brake request signals to the hybrid vehicle control ECU. If an abnormal signal is detected, the hyb
SEE MORE:
Operation Check
OPERATION CHECK CHECK AUTO OPERATION FUNCTION NOTICE:
Make sure that initialization has been completed before performing this inspection.
Click here
The sliding roof auto operation can be customized. Make sure that the auto operation customize setting is set to ON.
Click here HINT: When
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear shock absorber assembly removal/installation are shown below. Necessary Procedures After Parts Rem
