Lexus ES: Communication Error from ECM to VSC Invalid Serial Data Received (P163181)
DESCRIPTION
The skid control ECU (brake booster with master cylinder assembly) sends signals such as brake request signals to the hybrid vehicle control ECU. When the hybrid vehicle control ECU detects logic error signals sent from the skid control ECU (brake booster with master cylinder assembly) for a certain period of time, DTC P163181 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | DTC Output from |
|---|---|---|---|---|---|
| P163181 | Communication Error from ECM to VSC Invalid Serial Data Received | When the power switch is on (IG) and the dynamic radar cruise control system is operating, the hybrid vehicle control ECU detects logic error signals sent from the skid control ECU (brake booster with master cylinder assembly) for approximately 1 second or more. |
| Does not come on | Hybrid Control |
CAUTION / NOTICE / HINT
NOTICE:
Before replacing the hybrid vehicle control ECU, refer to Registration.
Click here .gif)
PROCEDURE
| 1. | CHECK FOR DTCs |
(a) Check for electronically controlled brake system DTCs.
Chassis > ABS/VSC/TRAC > Trouble Codes| Result | Proceed to |
|---|---|
| Electronically controlled brake system DTCs are not output | A |
| Electronically controlled brake system DTCs are output | B |
| B | .gif) | GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM |
|
.gif)
| 2. | CHECK FOR DTCs |
(a) Clear the DTCs.
Powertrain > Radar Cruise1 > Clear DTCs(b) Make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.
(c) Check for DTCs.
Powertrain > Radar Cruise1 > Trouble Codes| Result | Proceed to |
|---|---|
| DTC P163181 is not output | A |
| DTC P163181 is output | B |
| A | | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE HYBRID VEHICLE CONTROL ECU |
READ NEXT:
Lost Communication with Cruise Control Module Missing Message (U010487,U012287,U029387)
DESCRIPTION The hybrid vehicle control ECU communicates with each sensor and ECU via CAN communication. If any malfunction is detected in a CAN communication circuit, one or more CAN communication sys
Lost Communication with Multi-axis Acceleration Sensor Module Missing Message (U012587,U012687,U012987,U015587,U029387,U110687)
DESCRIPTION The forward recognition camera communicates with each sensor and ECU via CAN communication. If any malfunction is detected in a CAN communication circuit, one or more CAN communication sys
Lost Communication with Cruise Control Front Distance Range Sensor Single Sensor or Center Missing Message (U023587)
DESCRIPTION The forward recognition camera communicates with the millimeter wave radar sensor assembly via CAN communication. If a communication malfunction between the forward recognition camera and
SEE MORE:
Calibration
CALIBRATION ADJUST PARKING ASSIST MONITOR SYSTEM (a) The parking assist monitor system can be adjusted using diagnostic mode. (b) If the following operations are performed, it is necessary to perform adjustments and checks using diagnostic mode. Part Name Operation Adjustment Item Proceed t
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during outer rear view mirror assembly with cover removal/installation are shown below. Necessary Procedure Af
