Lexus ES manuals

Lexus ES: Precaution

PRECAUTION

PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the cable is reconnected.

System Name

See Procedure

Lane Control System (for HV Model)

Parking Support Brake System (for HV Model)

Parking Assist Monitor System (for HV Model)

Panoramic View Monitor System (for HV Model)

Pre-collision System (for HV Model)

Power Trunk Lid System (for HV Model)

Lighting System (for HV Model)

PRECAUTIONS FOR VEHICLE PROXIMITY NOTIFICATION SYSTEM

(a) In the following cases, the volume or tone of the sound might change:

(1) If the vehicle is parked in a very hot or cold environment for an extended period of time (function will return to normal after time passes)

(2) If high pressure water is applied directly to the speaker from the bottom of the vehicle

(3) If the front of the speaker is blocked by mud, snow, ice, etc.

(4) If the entire speaker freezes

(b) In the following cases, it may be difficult to hear the sound from the speaker:

(1) If the environment around the vehicle is very noisy (in a busy intersection or when an emergency vehicle is approaching)

(2) If the listener is behind the vehicle. (Compared to a situation such as when a pedestrian is in front of the vehicle, the sound volume will seem to be lower when the car is reversing. This occurs because the speaker is installed facing the front of the vehicle.)

READ NEXT:

 Parts Location

PARTS LOCATION ILLUSTRATION *1 VEHICLE APPROACHING SPEAKER ASSEMBLY *2 SKID CONTROL ECU (BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY) ILLUSTRATION *1 HYBRID VEHICLE CONTROL ECU *2

 System Diagram

SYSTEM DIAGRAM

 System Description

SYSTEM DESCRIPTION Vehicle Proximity Notification System (a) When the vehicle is being driven quietly using the motor only, the vehicle proximity notification system outputs a warning sound from the v

SEE MORE:

 Replacement

REPLACEMENT CAUTION / NOTICE / HINT HINT: Use the same procedure for bank 1 and bank 2. The following procedure is for bank 2. PROCEDURE 1. REPLACE INTAKE VALVE GUIDE BUSH (a) Heat the cylinder head LH to between 80 and 100°C (176 and 212°F). (b) Place the cylinder head LH on wooden blocks

 Transmission Fluid Temperature Sensor "A" Circuit Short To Ground (P071011)

DESCRIPTION The ATF temperature sensor converts the automatic transaxle fluid (ATF) temperature into a resistance value for use by the ECM. The ECM applies voltage to the temperature sensor through terminal THO1 of the ECM. The sensor resistance changes with the ATF temperature. As the temperature r

© 2016-2024 Copyright www.lexguide.net