Lexus ES: Precaution
PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the cable is reconnected.
| System Name | See Procedure |
|---|---|
| Lane Control System (for HV Model) | |
| Parking Support Brake System (for HV Model) | |
| Parking Assist Monitor System (for HV Model) | |
| Panoramic View Monitor System (for HV Model) | |
| Pre-collision System (for HV Model) | |
| Power Trunk Lid System (for HV Model) | |
| Lighting System (for HV Model) |
PRECAUTION FOR WASHER NOZZLE ADJUSTMENT
(a) Do not clean or adjust the washer nozzle with a safety pin, etc. because:
(1) The washer nozzle tip is made of resin and may be damaged.
(2) Adjustment is not necessary for this spray type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.
Click here .gif)
(b) If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.
PRECAUTIONS FOR RAIN SENSOR (w/ Auto Wiper System)
(a) When the power switch is on (IG) and the front wiper switch is in the AUTO position, the rain sensor may operate the front wipers if the rain sensor sensing portion of the windshield glass is touched by a hand or if something moist, such as a wet cloth, is brought near. This may lead to injury or damage to the vehicle.
(b) When the power switch is on (IG) and the front wiper switch is in the AUTO position, the rain sensor may operate the wipers if the rain sensor or parts around the rain sensor (windshield glass, rain sensor cover, etc.) are vibrated.
(c) If the windshield glass is coated with a water-repellent coating, the rain sensor may not correctly detect the amount of raindrops that strike the windshield and the auto wiper system may not operate normally.
(d) As the rain sensor is an optical sensor, if sunlight intermittently strikes the windshield glass or the rain sensor sensing portion of the windshield glass is dirty, the auto wiper system may not operate normally.
(e) The rain sensor cannot operate if the front wipers are stopped in any position other than the park position.
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *A w/ Auto Wiper System - - *1 WINDSHIELD WIPER MOTOR ASSEMBLY *2 RAIN SENSOR *3 LEVEL WARNING SWITCH ASSEMBLY *4 WINDSHIELD WASHER MOTOR AND
System Diagram
SYSTEM DIAGRAM FRONT WIPER AND WASHER SYSTEM WASHER FLUID LEVEL WARNING SYSTEM
System Description
SYSTEM DESCRIPTION FRONT WIPER AND WASHER CONTROL FUNCTION Control/Function Description Wiper speed regulation Maintains the default speed of the wipers even when the supply voltage or resi
SEE MORE:
Engine Coolant Temperature Sensor 1 Circuit Short to Battery or Open (P011515)
DESCRIPTION Refer to DTC P011511. Click here HINT: When DTC P011515 is stored, the ECM enters fail-safe mode. During fail-safe mode, the engine coolant temperature is estimated to be 80°C (176°F) by the ECM. Fail-safe mode continues until a pass condition is detected. DTC No. Detection Item
Mute Signal Circuit between Stereo Component Amplifier and Telematics Transceiver
DESCRIPTION The DCM (telematics transceiver) sends a mute signal to the stereo component amplifier assembly. The stereo component amplifier assembly controls the volume according to the mute signal from the DCM (telematics transceiver). WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
Depending on
