Lexus ES: Lost Communication with TCM (U0101,U0122,U0142,U0155,U0327,U1117)
DESCRIPTION
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0101 | Lost Communication with TCM | Communication malfunction detected between luggage closer motor assembly and ECM |
|
| U0122 | Lost Communication With Vehicle Dynamics Control Module | Communication malfunction detected between luggage closer motor assembly and brake actuator assembly (skid control ECU) |
|
| U0142 | Lost Communication With Body Control Module "B" | Communication malfunction detected between luggage closer motor assembly and main body ECU (multiplex network body ECU) |
|
| U0155 | Lost Communication With Instrument Panel Cluster (IPC) Control Module | Communication malfunction detected between luggage closer motor assembly and combination meter assembly |
|
| U0327 | Lost Communication with Vehicle Security Control Module | Communication malfunction detected between luggage closer motor assembly and certification ECU (smart key ECU assembly) |
|
| U1117 | Lost Communication with Accessory Gateway | Communication malfunction detected between luggage closer motor assembly and bus buffer ECU |
|
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Back Door / Trouble Codes.
(e) Clear the DTCs.
Body Electrical > Back Door > Clear DTCs(f) Check for DTCs.
Body Electrical > Back Door > Trouble CodesHINT:
If DTCs related to a malfunction in the CAN communication system are output, refer to "How to Proceed with Troubleshooting" for the CAN communication system.
Click here .gif)
OK:
DTC U0101, U0122, U0142, U0155, U0327 and U1117 is not output.
| OK | .gif) | USE SIMULATION METHOD TO CHECK |
| NG | | GO TO CAN COMMUNICATION SYSTEM |
READ NEXT:
Luggage Compartment Door Closer does not Operate
DESCRIPTION The luggage compartment door closer operation controls the luggage door closer assembly via the luggage closer motor assembly based on switch signals in the luggage door closer assembly. W
Power Trunk Lid does not Operate Using Any Switches
DESCRIPTION The power trunk lid controls the luggage closer motor assembly and operates the luggage closer motor assembly and luggage door closer assembly. If the power trunk lid does not operate usin
Power Trunk Lid does not Operate Using Cabin Switch
DESCRIPTION The trunk and fuel switch assembly (luggage compartment door opening switch) signal is sent to the luggage closer motor assembly. If the power trunk lid does not operate using the trunk an
SEE MORE:
Slave Module Horizontal Axis Misalignment (C1AC2)
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis. HINT:
If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor s
Generator Position Sensor Internal Electronic Failure (P1CAC49,P1C641F,P1CAF38)
DESCRIPTION The motor generator control ECU (MG ECU), which is built into the inverter with converter assembly, monitors its internal operation and detects malfunctions. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P1C641F Generator Control Modu
