Lexus ES manuals

Lexus ES: Installation

Lexus ES (XZ10) Service Manual / Suspension / Front Suspension / Front Lower Ball Joint / Installation

INSTALLATION

CAUTION / NOTICE / HINT

for HV Model:

  • When removing or installing the front disc brake caliper assembly, pushing back the disc brake piston may cause a large clearance between the brake pads and brake disc. When the brake pedal is depressed with a large clearance between the brake pads and the brake disc, DTC C1214 related to abnormal brake fluid pressure may be stored. Make sure to clear any DTCs after performing this procedure.
  • While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL FRONT LOWER BALL JOINT ASSEMBLY

(a) Secure the front axle assembly in a vise using aluminum plates.

NOTICE:

Do not overtighten the vise.

(b) Install the front lower ball joint assembly to the front axle assembly with the nut.

Torque:

133 N·m {1356 kgf·cm, 98 ft·lbf}

NOTICE:

  • Do not apply lubricants to the ball joint stud taper and threads.
  • Remove any foreign matter from the contact surface of the steering knuckle and ball joint stud taper.

(c) Install a new cotter pin.

NOTICE:

Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.

2. INSTALL FRONT AXLE ASSEMBLY

Click here

READ NEXT:

 Front Lower Suspension Arm

 Components

COMPONENTS ILLUSTRATION *A for A25A-FXS *B for 2GR-FKS *C Type A *D Type B *1 FRONT FENDER APRON SEAL LH *2 FRONT FLOOR COVER LH *3 FRONT WHEEL OPENING EXTENSION PA

 Components

COMPONENTS ILLUSTRATION *A for A25A-FXS, A25A-FKS *B for 2GR-FKS *C Type A *D Type B *1 FRONT FENDER APRON SEAL LH *2 FRONT FLOOR COVER LH *3 FRONT WHEEL OPENING EX

SEE MORE:

 Left Rear Wheel Speed Sensor Circuit Voltage Out of Range (C050C1C)

DESCRIPTION Refer to DTC C050C12 Click here DTC No. Detection Item DTC Detection Condition Trouble Area C050C1C Left Rear Wheel Speed Sensor Circuit Voltage Out of Range When the vehicle is being driven in a straight line at a speed of 20 km/h (12 mph) or more and VSC/TRAC has

 Installation

INSTALLATION PROCEDURE 1. INSTALL FUEL SENDER GAUGE ASSEMBLY (a) Engage the claw to install the fuel sender gauge assembly to the fuel sub-tank. NOTICE: Be careful not to bend the arm of the fuel sender gauge assembly. (b) Engage the 2 clamps to connect the wire harness to the fuel suction plate sub

© 2016-2024 Copyright www.lexguide.net