Lexus ES: HVAC Control Module to Hybrid Powertrain Control Module Invalid Serial Data Received (U042481)
DESCRIPTION
If the hybrid vehicle control ECU receives an invalid compressor control request from the air conditioning amplifier assembly via CAN communication, it will store this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate |
|---|---|---|---|---|---|
| U042481 | HVAC Control Module to Hybrid Powertrain Control Module Invalid Serial Data Received | Invalid control request received from the air conditioning amplifier assembly (1 trip detection logic) | Air conditioning amplifier assembly | Does not come on | Master Warning Light: Does not come on |
CONFIRMATION DRIVING PATTERN
HINT:
After repair has been completed, clear the DTCs and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.
Click here .gif)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG) and turn the Techstream on.
- Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
- Turn the power switch off and wait for 2 minutes or more.
- Turn the power switch on (IG) and turn the Techstream on.
- Wait for 1 minute or more with the vehicle stopped, the power switch on (READY), with the shift lever in P and the air conditioning system on (Lo/COOL MAX, blower speed HI).
- Turn the air conditioning system off and wait for 10 seconds or more with the power switch on (READY).
- Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.
-
Check the DTC judgment result.
HINT:
- If the judgment result shows NORMAL, the system is normal.
- If the judgment result shows ABNORMAL, the system has a malfunction.
- If the judgment result shows INCOMPLETE or N/A, perform driving pattern again.
PROCEDURE
| 1. | CHECK DTC OUTPUT (AIR CONDITIONER) |
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes.
(d) Check if DTCs related to the air conditioning system (A/C) are output.
Body Electrical > Air Conditioner > Trouble Codes| Result | Proceed to |
|---|---|
| DTCs related to A/C are not output. | A |
| DTCs related to A/C are output. | B |
(e) Turn the power switch off.
| A | .gif) | REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY |
| B | | GO TO DTC CHART (AIR CONDITIONING SYSTEM) |
READ NEXT:
Brake Override System
DESCRIPTION When the vehicle is being driven with the accelerator pedal depressed, depressing the brake pedal without releasing the accelerator pedal will activate the brake override system to restric
Transmission Control Switch Circuit
DESCRIPTION When the shift lever is in S, different ranges can be chosen using the floor shift sequential gate. WIRING DIAGRAM Refer to the wiring diagram for the shift paddle switch circuit. Click he
Shift Paddle Switch Circuit
DESCRIPTION Moving the shift lever to S enables the shift range to be selected. The shift range can be selected by operating the "+" or "-" shift paddle switch. WIRING DIAGRAM CAUTION / NOTICE / HINT
SEE MORE:
Precaution
PRECAUTION NOTICE: When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the terminal is reconnected. System Name See Procedure Lane Control System Pre-collision System Intelligent Clearance Sonar System Parking Assist
XM Tuner Antenna Disconnected (B15FE,B15FF)
DESCRIPTION These DTCs are stored when a malfunction occurs in the telephone antenna assembly which is connected to the radio receiver assembly. DTC No. Detection Item DTC Detection Condition Trouble Area B15FE XM Tuner Antenna Disconnected The telephone antenna assembly is not conn
