Lexus ES manuals

Lexus ES: Horn

Lexus ES (XZ10) Service Manual / Vehicle Exterior / Horn

READ NEXT:

 Horn

ComponentsCOMPONENTS ILLUSTRATION *1 COOL AIR INTAKE DUCT SEAL *2 HIGH PITCHED HORN ASSEMBLY *3 LOW PITCHED HORN ASSEMBLY - - N*m (kgf*cm, ft.*lbf): Specified torque -

 Horn System

 Parts Location

PARTS LOCATION ILLUSTRATION *A for Type A *B for Type B *1 HIGH PITCHED HORN ASSEMBLY *2 LOW PITCHED HORN ASSEMBLY *3 HORN RELAY *4 ENGINE ROOM RELAY BLOCK AND JUNCTION B

SEE MORE:

 Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (a) Remove the bolt. Remove in this Direction (b) Disengage the claw and guide as shown in the illustration to remove the map light bracket. (c) Remove the 2 bolts and sliding roof drive gear sub-assembly.

 Removal

REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear axle hub and bearing assembly removal/installation are shown below. Necessary Procedures After Par

© 2016-2025 Copyright www.lexguide.net