Lexus ES manuals

Lexus ES: Freeze Frame Data

FREEZE FRAME DATA

DESCRIPTION

(a) Whenever a lane control system DTC is stored, the forward recognition camera stores the current vehicle state as Freeze Frame Data.

CHECK FREEZE FRAME DATA

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Chassis / Lane Control / Trouble Codes.

Chassis > Lane Control > Trouble Codes

(e) According to the display on the Techstream, select a DTC to display its freeze frame data.

Chassis > Lane Control

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Total Distance Traveled

-

-

-

Cannot be used

Total Distance Traveled - Unit

-

-

-

Cannot be used

LDA Control

Lane control system control status

Prohibit or Permit

Prohibit: Control prohibited

Permit: Control permitted

-

Turn Switch (Right)

Right turn signal switch status

OFF or ON

ON: Right turn signal switch on

OFF: Right turn signal switch off

-

Turn Switch (Left)

Left turn signal switch status

OFF or ON

ON: Left turn signal switch on

OFF: Left turn signal switch off

-

Vehicle Information (2WD/4WD)

-

-

-

Cannot be used

Vehicle Information (Conv/HV)

-

-

-

Cannot be used

READ NEXT:

 Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa

 Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Lane Control System DTC No. Detection Item Link C1A7496 Steering Vibrator Component Internal Failure U012587 Lost Communication with Multi-axis Ac

 Vehicle Control History

VEHICLE CONTROL HISTORY NOTICE: Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again. CHECK VEHICLE CONTROL HISTORY (LANE CO

SEE MORE:

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspect

 Inspection

INSPECTION PROCEDURE 1. INSPECT CYLINDER BLOCK FOR WARPAGE (a) Using a precision straightedge and feeler gauge, check the surface which contacts the cylinder head gasket for warpage. Maximum Warpage: 0.05 mm (0.00197 in.) HINT: If the warpage is more than the maximum, replace the cylinder block

© 2016-2025 Copyright www.lexguide.net