Lexus ES manuals

Lexus ES: Dtc Check / Clear

Lexus ES (XZ10) Service Manual / Vehicle Interior / Sliding Roof / Convertible / Sliding Roof System (for Hv Model) / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Sliding Roof / Trouble Codes.

Body Electrical > Sliding Roof > Trouble Codes

(e) Check the details of the DTC(s).

Click here

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Sliding Roof / Trouble Codes.

Body Electrical > Sliding Roof > Clear DTCs

(e) Clear the DTCs.

READ NEXT:

 Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th

 Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Sliding Roof System DTC No. Detection Item Link B2341 Sensor (Motor) Failure B2342 Switch Failure B2343 Position Initialization Incompl

 Sensor (Motor) Failure (B2341,B2344)

DESCRIPTION When the sliding roof ECU (sliding roof drive gear sub-assembly) detects a motor malfunction and the sliding roof operation is stopped, DTC B2341 is stored. When the sliding roof ECU (slid

SEE MORE:

 Rear Power Window RH does not Operate with Rear Power Window Switch RH

DESCRIPTION When the power switch is on (IG), the power window regulator motor assembly (for rear RH door) is operated by the rear power window regulator switch assembly (for RH door). The power window regulator motor assembly (for rear RH door) has motor, regulator, and ECU functions. WIRING DIAGRA

 Inspection

INSPECTION PROCEDURE 1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (for 2WD) (a) Preparation for check (1) Confirm the standard, high and low positions of the link that will be used in the following inspection. The standard position is 58° from the maximum link angle (high) and 51° from

© 2016-2024 Copyright www.lexguide.net