Lexus ES: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Parking Support Brake System| DTC No. | Detection Item | Link |
|---|---|---|
| C1625 | Open or Short in Steering Angle Sensor +B | |
| C1626 | Steering Angle Sensor Failure | |
| C1647 | G Sensor Failure | |
| C164B | Communication Error From Clearance Sonar ECU to VSC | |
| C164D | Wheel Speed Sensor Malfunction | |
| C164E | Stop Switch Circuit Malfunction | |
| C164F | Brake Hydraulic Pressure Malfunction | |
| C1652 | Outside Air Temperature Sensor | |
| C1A40 | ENG / EHV Device | |
| C1A4B | Stop Light Relay Circuit | |
| C1A50 | Brake System | |
| C1AEA | Steering Angle Midpoint Initial Setting Incomplete | |
| C1AF0 | ICS Detection Area Adjustment Incomplete | |
| C1AF7 | RCTB Sensor | |
| C1AF9 | Blind Spot Monitor Beam Axis Inspection Incomplete | |
| C1AFA | Blind Spot Monitor Beam Axis Misalignment | |
| C2A63 | Back Camera Internal Circuit | |
| U0073 | Control Module Communication Bus "A" Off | |
| U0100 | Lost Communication with ECM / PCM "A" | |
| U0124 | Lost Communication with Lateral Acceleration Sensor Module | |
| U0126 | Lost Communication with Steering Angle Sensor Module | |
| U0129 | Lost Communication with Brake System Control Module | |
| U0140 | Lost Communication with Body Control Module | |
| U0155 | Lost Communication With Instrument Panel Cluster (IPC) Control Module | |
| U0164 | Lost Communication with HVAC Control Module | |
| U0232 | Lost Communication with Blind Spot Monitor Slave Module | |
| U0233 | Lost Communication with Blind Spot Monitor Master Module | |
| U0265 | Lost Communication with Image Processing Sensor A | |
| U1000 | CAN Communication Failure (Message Registry) | |
.gif)
READ NEXT:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Parking Support Brake System DTC No. Detection Item Link C1625 Open or Short in Steering Angle Sensor +B C1626 Steering Angle Sensor Failure
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the parking support brake system on. (d) Turn the Techstream on. (e) Enter the following
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) If a malfunction is detected in the parking support brake system, the warning message "Parking Support Brake Malfunction Visit Your Dealer", "Parking Support Bra
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pressure sensor removal/installation are shown below. Necessary Procedures After Parts Removed/Inst
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (CHECK USING TECHSTREAM) (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG) and wait for 90 seconds. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes. Body Electrical > Navigation Sys
