Lexus ES: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Parking Support Brake System| DTC No. | Detection Item | Link |
|---|---|---|
| C1625 | Open or Short in Steering Angle Sensor +B | |
| C1626 | Steering Angle Sensor Failure | |
| C1647 | G Sensor Failure | |
| C164B | Communication Error From Clearance Sonar ECU to VSC | |
| C164D | Wheel Speed Sensor Malfunction | |
| C164E | Stop Switch Circuit Malfunction | |
| C164F | Brake Hydraulic Pressure Malfunction | |
| C1652 | Outside Air Temperature Sensor | |
| C1A40 | ENG / EHV Device | |
| C1A4B | Stop Light Relay Circuit | |
| C1A50 | Brake System | |
| C1AEA | Steering Angle Midpoint Initial Setting Incomplete | |
| C1AF0 | ICS Detection Area Adjustment Incomplete | |
| C1AF7 | RCTB Sensor | |
| C1AF9 | Blind Spot Monitor Beam Axis Inspection Incomplete | |
| C1AFA | Blind Spot Monitor Beam Axis Misalignment | |
| C2A63 | Back Camera Internal Circuit | |
| U0073 | Control Module Communication Bus "A" Off | |
| U0100 | Lost Communication with ECM / PCM "A" | |
| U0124 | Lost Communication with Lateral Acceleration Sensor Module | |
| U0126 | Lost Communication with Steering Angle Sensor Module | |
| U0129 | Lost Communication with Brake System Control Module | |
| U0140 | Lost Communication with Body Control Module | |
| U0155 | Lost Communication With Instrument Panel Cluster (IPC) Control Module | |
| U0164 | Lost Communication with HVAC Control Module | |
| U0232 | Lost Communication with Blind Spot Monitor Slave Module | |
| U0233 | Lost Communication with Blind Spot Monitor Master Module | |
| U0265 | Lost Communication with Image Processing Sensor A | |
| U1000 | CAN Communication Failure (Message Registry) | |
.gif)
READ NEXT:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the parking support brake system on. (d) Turn the Techstream on. (e) Enter the following
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) If a malfunction is detected in the parking support brake system, the warning message "Parking Support Brake Malfunction Visit Your Dealer", "Parking Support Bra
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use the following procedure to troubleshoot the parking support brake system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT
SEE MORE:
O2 Sensor Circuit Bank 1 Sensor 2 Circuit Short to Ground (P013611,...,P015623)
DESCRIPTION In order to obtain a high purification rate of the carbon monoxide (CO), hydrocarbon (HC) and nitrogen oxide (NOx) components in the exhaust gas, a TWC (Three-Way Catalytic Converter) is used. For the most efficient use of the TWC, the air fuel ratio must be precisely controlled so that
Installation
INSTALLATION PROCEDURE 1. INSTALL FLOW SHUTTING VALVE (WATER BY-PASS HOSE ASSEMBLY) (a) Connect the flow shutting valve (water by-pass hose assembly) to the transmission oil cooler and slide the clip to secure it. *a 2 to 7 mm (0.0787 to 0.276 in.) *b Paint Mark *c 45° (Tabs of Clip
