Lexus ES manuals

Lexus ES: Customize Parameters

CUSTOMIZE PARAMETERS

CUSTOMIZE PANORAMIC MOON ROOF SYSTEM

NOTICE:

  • When the customer requests a change in a function, first make sure that the function can be customized.
  • Be sure to make notes of the current settings before customizing.
  • When troubleshooting a function, first make sure that the function is set to the default setting.

HINT:

The following items can be customized.

(a) Customizing with the Techstream

(1) Connect the Techstream to the DLC3.

(2) Turn the engine switch on (IG).

(3) Turn the Techstream on.

(4) Enter the following menus: Customize Setting / Power Window.

(5) Select the setting by referring to the table below.

Power Window

Tester Display

Description

Default

Setting

ECU

Door Key P/W Up

Function to close the power windows and sliding roof using the mechanical key

OFF

0:OFF,1:ON

Main body ECU (Multiplex network body ECU)

Door Key P/W Down

Function to open the power windows and sliding roof using the mechanical key

OFF

0:OFF,1:ON

Main body ECU (Multiplex network body ECU)

P/W Down W/ Transmit

Function to open the power windows and sliding roof using the wireless transmitter

OFF

0:OFF,1:ON

Main body ECU (Multiplex network body ECU)

(6) Enter the following menus: Customize Setting / Slide Roof.

(7) Select the setting by referring to the table below.

Slide Roof

Tester Display

Description

Default

Setting

ECU

Front SW Auto Operation

This function is used to enable or disable auto operation function.

ON

0:OFF,1:ON

Sliding roof ECU (Sliding roof drive gear assembly)

(8) Enter the following menus: Customize Setting / Security.

(9) Select the setting by referring to the table below.

Security

Tester Display

Description

Default

Setting

ECU

Slide Roof Open Warning

This function is used to enable or disable the sliding roof open warning.

ON

0:OFF,1:ON

Main body ECU (Multiplex network body ECU)

READ NEXT:

 Initialization

INITIALIZATION INITIALIZE PANORAMIC MOON ROOF SYSTEM (FOR SLIDING ROOF) NOTICE: When the sliding roof glass sub-assembly, sliding roof housing panel or slide roof rail sub-assembly is adjusted or r

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of

 Terminals Of Ecu

TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY) (a) Disconnect the Q1 sliding roof ECU (sliding roof drive gear assembly) connector. (b) Measure the resistance and voltage

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL MASS AIR FLOW METER SUB-ASSEMBLY HINT: Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly. Click here (a) Install the mass air flow meter sub-assembly to the air cleaner cap sub-assembly with the 2 screws. NOTICE: If the mas

 Short to +B in Outer Mirror Indicator(Master) (C1AB0)

DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects a short to +B in the outer rear view mirror indicator RH. DTC No. Detection Item DTC Detection Condition Trouble Area C1AB0 Short to +B in Outer Mirror Indicator(Master) Both of the following conditions ar

© 2016-2024 Copyright www.lexguide.net