Lexus ES: Customize Parameters
CUSTOMIZE PARAMETERS
CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
HINT:
The following items can be customized.
NOTICE:
-
When the customer requests a change in a function, first make sure that the function can be customized.
-
Record the current settings before customizing.
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the power switch on (IG).
(3) Turn the Techstream on.
(4) Enter the following menus: Body Electrical / Tilt & Telescopic / Utility / Customize.
(5) Select the setting by referring to the table below.
Tilt & Telesco
Tester Display | Description | Default | Setting | ECU |
Autoaway/Return Operation Setting | Turn the auto away/return function | Tilt ON | $0000:Tilt&Telescopic OFF,$0001:Telescopic ON,$0010:Tilt ON,$0011:Tilt&Telescopic ON | Multiplex tilt and telescopic ECU |
(b) Customizing with the multi-display
(1) Turn the power switch on (IG).
(2) Select the setting by referring to the table below
(3) Select the following menus: Setup / Vehicle / Vehicle Customization / Other Vehicle Settings.
(4) Select the setting by referring to the table below.
Other Vehicle Settings
Display | Description | Default | Setting | ECU |
Steering column easy-exit | Turn the auto away/return function | Tilt Only | Tilt & Telescopic / Tilt Only / Telescopic Only / Off | Multiplex tilt and telescopic ECU |
READ NEXT:
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of
TERMINALS OF ECU MULTIPLEX TILT AND TELESCOPIC ECU *a Component with harness connected (Multiplex Tilt and Telescopic ECU) - - (a) Measure the voltage and resistance according to the valu
TERMINALS OF ECU MULTIPLEX TILT AND TELESCOPIC ECU *a Component with harness connected (Multiplex Tilt and Telescopic ECU) - - (a) Measure the voltage and resistance according to the valu
SEE MORE:
TERMINALS OF ECU CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (a) Disconnect the J20 multiplex network master switch assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector discon
DESCRIPTION The idle speed is controlled by the Electronic Throttle Control System (ETCS). The ETCS is comprised of a throttle actuator, which operates the throttle valve, and a throttle position sensor, which detects the opening amount of the throttle valve. The ECM controls the throttle actuator t
© 2016-2025 Copyright www.lexguide.net
