Lexus ES: Check For Intermittent Problems
CHECK FOR INTERMITTENT PROBLEMS
NOTICE:
- If the vehicle or vehicle controls are operated (for example, during initial inspection when the vehicle is brought in for repair) before operation history has been read and saved, the operation history information could be lost.
- The operation history function uses the current system time of the Techstream and the time counter inside the controlling ECU to calculate the times shown in the operation history. For this reason, before reading the operation history, first make sure that the Techstream system clock is accurately set to the current time.
Operation History
HINT:
The main body ECU (multiplex network body ECU) stores Operation History, which can be read using the Techstream, when a malfunction of the power door lock control system occurs.
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Utility / Operation History.
Body Electrical > Main Body > Utility| Tester Display |
|---|
| Operation History |
(e) According to the display on the Techstream, read and save the operation history.
| Tester Display |
|---|
| Trunk Lid Open by Trunk SW Input |
| Trunk Lid Open by Trunk SW Input (Outside) |
| Trunk Lid Open by Key Linked Trunk SW Input |
| Trunk Lid Open by Wireless Key Input |
| Trunk Lid Open by Accessory Wireless Input |
| Trunk Lid Open by Auto Entry Key Input |
| Open by kick Sensor Input |
| Trunk Lid Open by Active Test |
| Back Door Open by Back Door SW Input (Auto Entry) |
| Back Door Open by Active Test |
| Back Door Open by Back Door SW Input |
| Fuel Lid Open by Fuel Lid Opener SW Input |
HINT:
Depending on the specifications of the vehicle some items may not be displayed.
Symptom Simulation
Click here .gif)
READ NEXT:
Operation Check
OPERATION CHECK CHECK CUSTOMIZE PARAMETERS (a) The operation check below is based on the non-customized initial condition of the vehicle. Click here OPERATION CONDITIONS (a) Operation conditions wh
Customize Parameters
CUSTOMIZE PARAMETERS CUSTOMIZE LUGGAGE COMPARTMENT DOOR OPENER SYSTEM NOTICE:
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to ma
Initialization
INITIALIZATION INITIALIZE LUGGAGE CLOSER MOTOR ASSEMBLY NOTICE: Initialization of the luggage closer motor assembly (luggage compartment door initial position learning) is necessary if the following w
SEE MORE:
"CHK" message(s) are displayed on the SIGNAL CHECK screen.
DESCRIPTION On the SIGNAL CHECK screen, it is possible to check if the signals sent to the parking assist ECU are normal. Click here HINT:
On the SIGNAL CHECK screen, "OK" (blue) is displayed for items with a normal inspection result or input state.
On the SIGNAL CHECK screen, "CHK" (red) is
Crankshaft Position Sensor "A" Circuit Short to Ground (P033511,P033515)
DESCRIPTION The crankshaft position sensor system consists of a No. 1 crankshaft position sensor plate and Magneto Resistance Element (MRE) type sensor. The No. 1 crankshaft position sensor plate has 34 teeth at 10° intervals (2 teeth are missing for detecting top dead center), and is installed on
