Lexus ES manuals

Lexus ES: Steering Angle Initialization Incomplete (C1694)

Lexus ES (XZ10) Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Panoramic View Monitor System (for Gasoline Model) / Steering Angle Initialization Incomplete (C1694)

DESCRIPTION

  • This DTC is stored when the parking assist ECU judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).
  • This DTC is stored when the rear television camera assembly judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1694

Steering Angle Initialization Incomplete

Maximum steering angle has not been memorized
  • Steering angle setting
  • Parking assist ECU

CAUTION / NOTICE / HINT

NOTICE:

  • When "!" is displayed on the multi-display assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

    Click here

PROCEDURE

1.

PERFORM SETTINGS (STEERING ANGLE SETTING)

(a) Perform the following procedure depending on the memory conditions to register the vehicle information to the parking assist ECU.

(1) Refer to steering angle setting.

Click here

NEXT

2.

CHECK FOR DTC

(a) Clear the DTCs.

Chassis > Circumference Monitoring Camera Control Module > Clear DTCs Chassis > Rear Camera > Clear DTCs

(b) Check for DTCs.

Chassis > Circumference Monitoring Camera Control Module > Trouble Codes Chassis > Rear Camera > Trouble Codes

HINT:

  • If DTC C1694 is output, perform the steering angle setting again.
  • If DTC C1694 is still output after performing the steering angle setting 3 times, replace the parking assist ECU.

Result

Proceed to

No DTCs are output

A

DTC C1694 is output ("Panoramic View Monitor")

B

DTC C1694 is output ("Parking Assist Camera")

C
A

END (SETTINGS ARE DEFECTIVE)
B

REPLACE PARKING ASSIST ECU

C

REPLACE REAR TELEVISION CAMERA ASSEMBLY

READ NEXT:

 Camera Position Adjustment Incomplete (C1697)

DESCRIPTION This DTC is stored when the parking assist ECU judges that the camera initial setting has not been memorized (camera view adjustment is incomplete). DTC No. Detection Item DTC Detec

 Calibration

CALIBRATION ADJUST PANORAMIC VIEW MONITOR SYSTEM (a) This panoramic view monitor system can be set from the diagnostic screen of the multi-display assembly. (b) If the following operations are perform

 Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL RADIATOR SHUTTER SUB-ASSEMBLY (a) Engage the 2 guides as shown in the illustration. Install in this Direction (b) Install the radiator shutter sub-assembly with the 3 bolts. Torque: 5.5 N·m {56 kgf·cm, 49 in·lbf} (c) Engage the clamp. (d) Connect the c

 On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. FUEL PUMP ASSEMBLY OPERATION (a) Check fuel pressure. (1) Connect the Techstream to the DLC3. (2) Turn the power switch on (IG). (3) Turn the Techstream on. (4) Put the engine in Inspection Mode (Maintenance Mode). Powertrain > Hybrid Control > Utility Tes

© 2016-2024 Copyright www.lexguide.net