Lexus ES: Registration
REGISTRATION
CAUTION / NOTICE / HINT
PROCEDURE
1. VIN (VEHICLE IDENTIFICATION NUMBER)
NOTICE:
The Vehicle Identification Number (VIN) must be written to a replacement ECM.
HINT:
The VIN is a 17-digit alphanumeric vehicle identification number. The Techstream is required to register the VIN.
(a) DESCRIPTION
HINT:
This registration section consists of 2 parts: Read VIN and Write VIN.
(1) Read VIN: This procedure allows the VIN stored in the ECM to be read in order to confirm that the 2 VINs, provided with the vehicle and stored in the vehicle ECM, are the same.
(2) Write VIN: This procedure allows the VIN to be written into the ECM. If the ECM is replaced, or the ECM VIN and vehicle VIN do not match, the VIN can be registered, or overwritten in the ECM by following this procedure.
(b) READ VIN
(1) Confirm the vehicle VIN.
(2) Connect the Techstream to the DLC3.
(3) Turn the engine switch on (IG).
(4) Turn the Techstream on.
(5) Enter the following menus: Powertrain / Engine / Utility / VIN / VIN Read.
Powertrain > Engine > Utility| Tester Display |
|---|
| VIN |
(6) According to the display on the Techstream, read the VIN stored in the ECM.
(c) WRITE VIN
(1) Confirm the vehicle VIN.
(2) Connect the Techstream to the DLC3.
(3) Turn the engine switch on (IG).
(4) Turn the Techstream on.
(5) Enter the following menus: Powertrain / Engine / Utility / VIN / VIN Write.
Powertrain > Engine > Utility| Tester Display |
|---|
| VIN |
(6) According to the display on the Techstream, write the VIN to the ECM.
READ NEXT:
Initialization
INITIALIZATION Inspection After Repair Perform Learning Value Reset and Idle Learning after replacing or servicing parts related to engine operation. Details on procedures required are indicated by an
Checking Monitor Status
CHECKING MONITOR STATUS The purpose of the monitor result (mode 06) is to allow access to the results of on-board diagnostic monitoring tests of specific components/systems that are not continuously m
Readiness Monitor Drive Pattern
READINESS MONITOR DRIVE PATTERN PURPOSE OF READINESS TESTS
The On-Board Diagnostic (OBD II) system is designed to monitor the performance of emission related components, and indicate any detected a
SEE MORE:
Exhaust Gas Recirculation "A" Flow (P040000-P04029B)
DESCRIPTION Based on the driving conditions, the ECM regulates the volume of exhaust gas that is recirculated to each engine cylinder in order to lower the combustion temperature and reduce NOx emissions. The ECM monitors signals such as engine speed, engine coolant temperature, electric load, and v
Automatic air conditioning system
Air outlets and fan speed are automatically adjusted according to the
temperature
setting.
Press the "MENU" button on the Remote Touch, then select "Climate" to display
the air conditioning control screen.
12.3-inch display model: The air conditioning system can be displayed and
operated
