Lexus ES manuals

Lexus ES: Precaution

Lexus ES (XZ10) Service Manual / Vehicle Interior / Window / Glass / Power Window Control System (for Gasoline Model) / Precaution

PRECAUTION

PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

System Name

See Procedure

Lane Control System (for Gasoline Model)

Parking Support Brake System (for Gasoline Model)

Parking Assist Monitor System (for Gasoline Model)

Panoramic View Monitor System (for Gasoline Model)

Pre-collision System (for Gasoline Model)

Power Trunk Lid System (for Gasoline Model)

Lighting System (for Gasoline Model)

POWER WINDOW CONTROL SYSTEM PRECAUTIONS

NOTICE:

  • The power window control system uses the LIN communication system and CAN communication system. Inspect the communication functions by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.

    Click here

  • The power window control system prohibits the auto up and down functions if the jam protection function or catch protection function malfunctions.
  • If a power window regulator motor assembly has been replaced with a new one, initialize a power window control system.

    Click here

  • If a power window regulator motor assembly and door window regulator sub-assembly have been removed and installed, or if a power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system.

    Click here

  • The jam protection function or catch protection function may operate unexpectedly, even when the power window control system is normal, due to detection of a value different than the operation learned value when the door glass moving speed changes sharply under any of the following conditions:
    1. A power window is being opened or closed while the vehicle is driven on a rough road.
    2. A power window is being opened or closed while the door is being opened or closed.
    3. The voltage changes abruptly.
  • Do not disconnect the battery while the engine switch is on (IG). Otherwise, DTC B2313 will be stored.

    Click here

READ NEXT:

 Parts Location

PARTS LOCATION ILLUSTRATION *1 MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *2 COMBINATION METER ASSEMBLY *3 DLC3 *4 CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) *5 INSTRUMENT PA

 System Diagram

SYSTEM DIAGRAM Communication Table Transmitting ECU Receiving ECU Signal Communication Method Multiplex Network Master Switch Assembly Power Window Regulator Motor Assembly (for Driv

 System Description

SYSTEM DESCRIPTION POWER WINDOW CONTROL SYSTEM DESCRIPTION (a) The power window control system controls the power window operation using the power window regulator motor assemblies. The main controls

SEE MORE:

 EPS Warning Light Circuit

CAUTION / NOTICE / HINT NOTICE: Perform this troubleshooting procedure when no DTCs are output, including DTCs related to CAN communication system malfunctions. If the customer reports that the steering feels heavy, refer to the "Heavy steering" item in the Problem Symptoms Table. Click here

 Position Initialization Incomplete (B2343)

DESCRIPTION This DTC is stored when the sliding roof ECU (sliding roof drive gear assembly) has not been initialized. DTC No. Detection Item DTC Detection Condition Trouble Area B2343 Position Initialization Incomplete Sliding roof ECU (sliding roof drive gear assembly) has not been

© 2016-2024 Copyright www.lexguide.net