Lexus ES manuals

Lexus ES: Key-off Operation Function Operates even if Operating Conditions are not Satisfied

Lexus ES (XZ10) Service Manual / Vehicle Exterior / Window / Glass / Power Window Control System (for Hv Model) / Key-off Operation Function Operates even if Operating Conditions are not Satisfied

DESCRIPTION

When the front doors are closed, each power window regulator motor assembly can be operated for approximately 45 seconds after the power switch is turned from on (IG) to off by receiving operation permission signals from the main body ECU (multiplex network body ECU). However, when approximately 45 seconds have elapsed, or the driver door or front passenger door is opened within approximately 45 seconds of the power switch being turned off, the power window regulator motor assemblies stop operating.

During auto operation, when 45 seconds have elapsed and key-off operation is prohibited, the power window stops immediately.

CAUTION / NOTICE / HINT

NOTICE:

  • The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.

    Click here

  • If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system.

    Click here

  • Before replacing the main body ECU (multiplex network body ECU), refer to Registration.

    Click here

PROCEDURE

1.

CHECK MANUAL UP / DOWN FUNCTION

(a) Check that the manual up and down functions using the multiplex network master switch assembly, power window regulator switch assembly and rear power window regulator switch assembly (for LH or RH door) can operate the power windows.

Click here

OK:

Manual up and down functions are normal.

NG

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table)

OK

2.

CHECK REMOTE UP / DOWN FUNCTION

(a) Check that the remote up and down functions using the multiplex network master switch assembly can operate all of the power windows.

Click here

OK:

Remote up and down functions are normal.

NG

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table)

OK

3.

CHECK KEY-OFF OPERATION FUNCTION

(a) Check the key-off operation function.

Click here

Result

Proceed to

Power window can be operated even after opening driver door or front passenger door within approximately 45 seconds of power switch being turned off

A

Power window can be operated even after approximately 45 seconds have elapsed since power switch was turned off (for All Doors)

B

Power window can be operated even after approximately 45 seconds have elapsed since power switch was turned off (for Driver Door or Front Passenger Door)

C

Power window can be operated even after approximately 45 seconds have elapsed since power switch was turned off (for Rear LH Door or Rear RH Door)

D

B

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

C

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Door or Front Passenger Door)

D

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Door or Rear RH Door)

A

4.

READ VALUE USING TECHSTREAM (MAIN BODY)

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Main Body / Data List.

(e) Read the Data List according to the display on the Techstream.

Body Electrical > Main Body > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

FR Door Courtesy SW

Front door courtesy light switch assembly (for RH) signal

OFF or ON

OFF: Front door RH closed

ON: Front door RH open

-

FL Door Courtesy SW

Front door courtesy light switch assembly (for LH) signal

OFF or ON

OFF: Front door LH closed

ON: Front door LH open

-

Body Electrical > Main Body > Data List

Tester Display

FR Door Courtesy SW

FL Door Courtesy SW

OK:

On the Techstream screen, ON or OFF is displayed accordingly.

OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

GO TO LIGHTING SYSTEM (Proceed to Front Door Courtesy Switch Circuit)

READ NEXT:

 Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)

DESCRIPTION If a door glass does not slide smoothly or a power window regulator motor assembly or door window regulator sub-assembly does not operate smoothly, the jam protection function may be trigg

 Auto Down Operation does not Fully Open Power Window (Catch Protection Function is Activated)

DESCRIPTION If a door glass does not slide smoothly or a power window regulator motor assembly or door window regulator sub-assembly does not operate smoothly, the catch protection function may be tri

 Jam Protection Function does not Operate

DESCRIPTION This symptom may occur for any of the power windows. The jam protection function operates within a specified range during the manual up or auto up operation. CAUTION / NOTICE / HINT NOTIC

SEE MORE:

 Internal Control Module EEPROM Data Memory Failure (P062F44)

DESCRIPTION The ECM monitors its internal operation and will store this DTC when it detects an internal malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P062F44 Internal Control Module EEPROM Data Memory Failure ECM internal malfunction

 Components

COMPONENTS ILLUSTRATION *1 COOL AIR INTAKE DUCT SEAL *2 FRONT BUMPER ASSEMBLY *3 FRONT BUMPER SIDE MOUNTING BRACKET - - ILLUSTRATION *A for Bar Type Radiator Grille - - *1 FRONT BUMPER EXTENSION MOUNTING BRACKET - - ILLUSTRATION *A for Mesh Type Ra

© 2016-2024 Copyright www.lexguide.net