Lexus ES: Fuel Pump
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 REAR SEAT INNER BELT ASSEMBLY LH *2 REAR CENTER SEAT LAP TYPE BELT ASSEMBLY *3 WASHER *4 REAR SEAT CUSHION ASSEMBLY *5 REAR SEAT CUSHION LOCK HOOK
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT NOTICE: Do not disconnect the tube shown in the illustration when disassembling the fuel suction tube with pump and gauge assembly. Doing so will cause reassembly o
Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL PUMP (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Specified Condition U - V 0.05
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 ENGINE WIRE *2 FRONT NO. 1 ENGINE MOUNTING BRACKET LH *3 WATER INLET WITH THERMOSTAT SUB-ASSEMBLY *4 GASKET *5 WATER BY-PASS HOSE *6 WIRE HARNESS CLAMP BRACKET *7 NO. 2 ENGINE MOUNTING STAY RH - - N*m (kgf*cm, ft.*lbf): Specif
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU Install in this direction (a) Engage the 2 claws to install the multiplex tilt and telescopic ECU. 2. INSTALL STEERING LOCK ACTUATOR ASSEMBLY NOTICE: After replacing the steering lock actuator assembly, perform registration.
© 2016-2024 Copyright www.lexguide.net
