Lexus ES: Fail-safe Chart
FAIL-SAFE CHART
PROTECTION FUNCTION
(a) The windshield wiper motor assembly operates the following protection functions if it detects an abnormal condition, in order to protect the wiper and washer system.
| Item | Protection Content | Conditions to Return to Normal Condition |
|---|---|---|
| Overheat protection | Decreases wiper operating speed in order to protect the windshield wiper motor assembly if the windshield wiper motor assembly temperature becomes excessively high.
| The windshield wiper motor assembly returns to normal. |
| Snow protection | Reverses the direction of the wipers and decreases their operating range when an excessive load, due to snow, etc., is detected near the extremities of the wiper operating range. In this case, operation is stopped at the lower reverse position for a certain period of time to prevent the motor from overheating. | Foreign matter, such as snow, is removed and the wiper operating range returns to normal. |
| Excessive load protection | Stops wiper operation when an excessive load is detected when the wipers are near the center of the wiper operating range. | The front wiper switch is turned off and then to any operating position. |
RAIN SENSOR FAIL-SAFE FUNCTION (w/ Auto Wiper System)
(a) The rain sensor performs fail-safe functions when it cannot properly receive necessary signals for wiper system control or a wiper system component is malfunctioning.
| Item | Fail-safe Function | Conditions to Return to Normal Condition |
|---|---|---|
| Rain sensor voltage is too low | Continues control according to the conditions detected before the malfunction | Rain sensor voltage returns to normal |
| The rain sensor temperature is excessively high (90°C (194°F) or higher) | Stops the wiper operation | Rain sensor returns to normal |
| The rain sensor temperature is excessively low (-15°C (5°F) or lower) | ||
| Rain sensor LIN communication error | LIN communication returns to normal | |
| Windshield wiper motor position signal error | Windshield wiper motor position signal returns to normal | |
| Abnormal rain sensor signal | Performs intermittent operation according to the position of the auto sensitivity adjustment switch | Rain sensor returns to normal |
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Wiper and Washer System DTC No. Detection Item DTC Output from Link B1245 Lost Communication with Wiper ECU LIN Main Body B1279 Lost Communica
Lost Communication with Wiper ECU LIN (B1245)
DESCRIPTION The main body ECU (multiplex network body ECU) and windshield wiper motor assembly communicate via LIN communication. The main body ECU (multiplex network body ECU) stores this DTC if comm
SEE MORE:
Freeze Frame Data
FREEZE FRAME DATA DESCRIPTION (a) Whenever a front radar sensor system DTC is stored, the millimeter wave radar sensor assembly stores the current vehicle state as Freeze Frame Data. CHECK FREEZE FRAME DATA (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techs
Luggage Compartment Door Opener Outer Switch
ComponentsCOMPONENTS ILLUSTRATION *1 LUGGAGE ELECTRICAL KEY SWITCH - - RemovalREMOVAL PROCEDURE 1. REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY Click here 2. REMOVE LUGGAGE ELECTRICAL KEY SWITCH (a) Disconnect the connector. (b) Disengage the clamp. (c
