Lexus ES: Disassembly
Lexus ES (XZ10) Service Manual / Vehicle Interior / Mirror (ext) / Outer Rear View Mirror / Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. REMOVE OUTER MIRROR
Click here .gif)
2. REMOVE OUTER MIRROR COVER ASSEMBLY
Click here
3. REMOVE SIDE TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System)
Click here
4. REMOVE OUTER MIRROR LOWER COVER
Click here
5. REMOVE OUTER MIRROR UPPER COVER
Click here
6. REMOVE VISOR COVER ASSEMBLY
Click here
READ NEXT:
Inspection
INSPECTION PROCEDURE 1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH (a) Check the operation of the mirror surface. NOTICE: If the mirror surface is fully turned to the right, left, upward or downward p
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL VISOR COVER ASSEMBLY Click here
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU HEATED STEERING WHEEL CONTROLLER (STEERING VIBRATION ECU) (a) Measure the voltage or resistance according to the value(s) in the table below. HINT: Perform the inspection from the harness side with the connectors connected. Terminal No. (Symbol) Terminal Description Conditio
System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Line Main Body ECU (Multiplex Network Body ECU) Sliding Roof ECU (Sliding Roof Drive Gear Assembly)
Sliding roof operation permission signal
IG signal
Front door courtesy light switch assembly signal
Vehicle speed
© 2016-2024 Copyright www.lexguide.net
