Lexus ES: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Audio and Visual System| DTC No. | Detection Item | Link |
|---|---|---|
| B1323 | Lost Communication with Haptic Device | |
| B1324 | Lost Communication with Meter | |
| B1326 | Lost Communication with Clock Device (Local-CAN) | |
| B1551 | HD Radio Tuner Malfunction | |
| B1559 | Touch Pad Sensor Malfunction | |
| B155A | Touch Pad Vibration Driver Malfunction | |
| B155B | Touch Pad Memory Module Malfunction | |
| B1574 | GVIF Disconnected (from Park Assist/Monitoring ECU to EMV/MM Integrated Device) | |
| B1575 | GVIF Disconnected (from EMV/MM Integrated Device to Multi Display) | |
| B1579 | Voice Recognition Microphone Disconnected | |
| B1585 | USB Device Malfunction | |
| B158F | AV Signal Stoppage (Low Battery Voltage) | |
| B15A0 | LAN Master Malfunction | |
| B15A3 | Stereo Component Amplifier Malfunction | |
| B15A6 | Display Malfunction | |
| B15B0 | Display Screen Malfunction | |
| B15B3 | Radio Tuner Malfunction | |
| B15B4 | CD Changer Malfunction | |
| B15B7 | Bluetooth Module Malfunction | |
| B15BA | XM Tuner Malfunction | |
| B15C0 | GPS Antenna Connection Malfunction(short) | |
| B15C1 | GPS Antenna Connection Malfunction(break) | |
| B15C3 | Speaker Output Short | |
| B15D3 | Stereo Component Amplifier Disconnected | |
| B15D6 | Display Disconnected | |
| B15D9 | Operation Panel Disconnected | |
| B15DB | Telematics Transceiver Disconnected | |
| B15F5 | Air Conditioner ECU Vehicle Information Reading/Writing Processor Malfunction | |
| B15F6 | Main Body ECU Vehicle Information Reading/Writing Process Malfunction | |
| B15F7 | Certification ECU Vehicle Information Reading/Writing Process Malfunction | |
| B15F8 | D-Seat ECU Vehicle Information Reading/Writing Process Malfunction | |
| B15F9 | UART Communication Malfunction(for A/C) | |
| B15FE | XM Tuner Antenna Disconnected | |
| B15FF | XM Tuner Antenna Short | |
| C1610 | Camera ECU Malfunction | |
| C1622 | Back Camera Disconnected | |
| U0073 | Sending Malfunction (Navigation to APGS) | |
| U0100 | Engine ECU Communication | |
| U0129 | VSC(ECB)ECU Communication | |
| U0140 | Lost Communication with Body Control Module | |
| U0155 | Meter ECU Communication | |
| U0164 | Air Conditioner ECU Communication | |
| U0198 | Lost Communication with Telematic Control Module | |
| U023B | Lost Communication with Image Processing Module "B" | |
| U0265 | Lost Communication with Image Processing Sensor A | |
| U0293 | HV ECU Communication | |
| U1110 | Clearance Sonar ECU Communication | |
.gif)
READ NEXT:
Display does not Dim when Light Control Switch is Turned ON
DESCRIPTION When the audio and visual system is activated with the light control switch in the tail or head position, before AVC-LAN communication is established, the multi-display assembly dims the d
Does not Play even after Bluetooth Audio Mode is Selected
CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (CHECK USING TECHSTREAM) (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG) and wait for 90 seconds. (c) Turn the Techstream on. (d) Enter the follow
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during direct fuel injector assembly removal/installation are shown below. Necessary Procedures After Parts Rem
Open in B Power Line (B242F)
DESCRIPTION The headlight ECU sub-assembly operates using the power source voltage input from the IG terminal and ECUB terminal. The power source voltage of the ECUB terminal is supplied when the main body ECU (multiplex network body ECU) turns the ECUB power supply relay (H-LP LH relay and H-LP RH
