Lexus ES: Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Navigation System / Data List.
(e) Read the Data List according to the display on the Techstream.
Body Electrical > Navigation System > Data List| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Battery Voltage | Battery voltage | Min.: 0 V, Max.: 24 V | 11 to 14 V | - |
| Active Dimmer | Active dimmer function | ON or OFF | ON: Active dimmer function on OFF: Active dimmer function off | - |
| Tail Light SW | Taillight switch | ON or OFF | ON: Light control switch in tail or head position OFF: Light control switch off or AUTO | - |
| Reverse Signal | Reverse signal | ON or OFF | ON: Shift lever in R OFF: Shift lever not in R | - |
| Parking Brake | Parking brake switch | ON or OFF | ON: Parking brake applied OFF: Parking brake released | - |
| Ignition | Engine switch | ON or OFF | ON: Engine switch on (IG) OFF: Engine switch off or on (ACC) | "OFF" is displayed even though the engine switch is on (ACC) |
| Vehicle Speed | Maximum wheel speed sensor reading | Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) | Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| HDMI Line(Blu-ray Disc Player) | - | Disconnected or Connected | Disconnected | Not available |
READ NEXT:
Data Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1.
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Navigation System DTC No. Detection Item Link B1323 Lost Communication with Haptic Device B1324 Lost Communication with Meter B1325 Los
Disc cannot be Ejected
CAUTION / NOTICE / HINT NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Pre
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear stabilizer bar removal/installation are shown below. Necessary Procedures After Parts Removed/Inst
Components
COMPONENTS
ILLUSTRATION
*1
FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT
*2
FRONT DISC BRAKE PAD
*3
FRONT DISC BRAKE CYLINDER ASSEMBLY
*4
FRONT DISC BRAKE PAD WEAR INDICATOR PLATE
*5
