Lexus ES: Components
Lexus ES (XZ10) Service Manual / Vehicle Interior / Mirror (ext) / Outer Rear View Mirror Glass / Components
COMPONENTS
ILLUSTRATION
| *1 | OUTER MIRROR | - | - |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE OUTER MIRROR (a) Apply protective tape
Inspection
INSPECTION PROCEDURE 1. INSPECT OUTER MIRROR RH (a) Check the outer mirror heater operation. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL OUTER MIRROR (a) w/o Blind Spot
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH for A25A-FKS: Click here for A25A-FXS: Click here for 2GR-FKS: Click here 2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH for A25A-FKS: Click here for A25A-FXS: Click here for 2GR-FKS: Click here 3. REMOVE NO. 1 ENGINE
Blind Spot Monitor Beam Axis Inspection Incomplete (C1AF9)
DESCRIPTION This DTC is stored when the clearance warning ECU assembly receives a signal from the blind spot monitor system via CAN communication indicating that the beam axis inspection is incomplete. DTC No. Detection Item DTC Detection Condition Trouble Area C1AF9 Blind Spot Monito
© 2016-2024 Copyright www.lexguide.net
