Lexus ES: A25a-fxs (engine Control)
Lexus ES (XZ10) Service Manual / Engine & Hybrid System / A25a-fxs (engine Control)
- Air Fuel Ratio Sensor (for Sensor 1)
- Air Fuel Ratio Sensor (for Sensor 2)
- Camshaft Oil Control Solenoid
- Camshaft Oil Control Valve
- Camshaft Position Sensor
- Camshaft Timing Control Motor
- Crankshaft Position Sensor
- Ecm
- Engine Coolant Temperature Sensor
- Ignition Coil And Spark Plug
- Ignition System
- Knock Sensor
- Mass Air Flow Meter
- Relay
- Sfi System
- Throttle Body
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 AIR FUEL RATIO SENSOR *2 NO. 1 ENGINE COVER SUB-ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque * For use with SST
Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during air
SEE MORE:
IG1 Voltage Supply too High (C1417,C14DF)
DESCRIPTION If a malfunction is detected in the power source circuit, the skid control ECU (brake booster with master cylinder assembly) stores DTC C1417 and prohibits operation of ABS, brake assist, regenerative brake cooperative control, etc. DTC C1417 is stored if an excessive ECU voltage due to
Brake Warning Light Remains ON
DESCRIPTION This procedure is for troubleshooting when the brake warning light / red (malfunction) remains on but no DTCs are output. The skid control ECU (brake actuator assembly) controls the brake warning light / red (malfunction) in the combination meter assembly via CAN communication. WIRING DI
© 2016-2024 Copyright www.lexguide.net
